Electrical

BEP Distribution Stud, Secondary Buss Fitted to a distribution stud, it allows for small wire connections without cluttering main stud. Tinned brass construction. ## Specifications## Specifications Chart BLA Code Length mm Width mm Main Stud...

BEP Double Pole Battery Master Switch Designed to isolate both positive and negative circuits as required in some commercial vessel installations. It is not recommended for switching house and start battery systems at the same time for safety reasons...

BEP Drop Resistor 32 Way BEP drop resistors for 24 Volt installations.

Drop resistor BEP 8 way  Drop Resistors compatible with BEP contour circuit breaker panels. Required for LED's of panels when installed in 24 volt systems. One Drop Resistor per panel is required. Suits: 113142-BLA 113144-BLA...

Drop resistor BEP 24 way  Drop Resistors compatible with BEP contour circuit breaker panels. Required for LED's of panels when installed in 24 volt systems. One Drop Resistor per panel is required. Suits: 113174-BLA 113175-BLA...

BEP Dual Trumpet Air Horns - White Epoxy Coated • Non-corrosive Lexan polycarbonate diaphragm• Includes compressor, air tubing, fittings, and hardware• Dimensions: 17" L x 7" W x 3. 75" H• Maximum amp draw: 12 volt: 20 amps, 24 volt:...

BEP Dynaplate The easy and effective answer to hull bonding and grounding. Improves performance of electronics and reduces RF interference. Sintered porous bronze spheres for maximum conductivity in a compact size. Low drag, non fouling shape. Scrapes...

BEP Easyfit Battery Master Switch Through panel mount battery master switch with removable threaded ring allows for fast installation in panel thicknesses up to 19mm. Control knob cannot be removed whilst in the on or off position, but is removable at an...

BEP Fuse Battery Terminal Mount Rating - 100 Amps Simply mounted to a 3/8” battery post, battery switch or bus bar the holder utilizes space saving ignition protected fuses for DC systems of 80 to 200A to a maximum of 58 volts. Designed for the...

BEP Heavy Duty Blade Fuse & Holder - 60 Amp Fuse Only In-line heavy duty fuse holder for installations where space is limited.   Supplied with 8mm² wire tails. Fuses are sold separately.   Fuse holder is 80(l) x 55(h) x 15(w) mm...

BEP Heavy Duty Blade Holder In-line heavy duty fuse holder for installations where space is limited. Supplied with 8mm² wire tails. Uses Blue Sea System Maxi Blade Fuses, sold separately Fuse holder is 80(l) x 55(h) x 15(w) mm. ##...

BEP Heavy Duty Busbar Tin plated brass busbar with insulated mounting base and four heavy duty studs. Meets ABYC standards. ## Specifications## Specifications Chart BLA Code Take Offs Length mm Height mm Current Rating Voltage...