Trim Tabs

Lenco Trim Tab Kits - Edge Mount - Without Switch • 2 x Edge Mount Plates, 12 Gauge (2.7mm) - 304G stainless steel with 1 inch turned up edges with a 5 degree taper on both sides to the trailing edge and 1/8 inch diameter hinge pin.• 2 x 12...

Lenco Trim Tab Kits - Standard Mount - LED Indicator Tactile Switch With Built-In Auto Retract • Built-in auto retract.• 12/24 volt.• LED indicator displays the exact position of your trim tabs, Auto brightness adjusting.• Self check...

Lenco Trim Tab Kits - Standard Mount - Standard Tactile Switch With Built-In Auto Retract   • 2 x Standard Mount Plates, 12 Gauge (2.7mm) - 304G stainless steel with a 5/8 inch flared trailing edge and 1/8 inch diameter hinge pin.• 2 x 12...

Lenco Trim Tab Kits - Standard Mount - With Double Rocker Switch • 2 x Standard Mount Plates, 12 Gauge (2.7mm) - 304G stainless steel with a 5/8 inch flared trailing edge and 1/8 inch diameter hinge pin.• 2 x 12 volt 101 actuators with 1.8m...

Lenco Trim Tab Limited Space 4x12 Electro Polish Trim tab plate only Lenco Limited Space 4x12 electro polish - single   Specifications Chart Part No. 55590-SAM Length 4 inch (101.6mm) Width 12 inch (305mm) Series Limited...

Lenco Trim Tab Plate Only 5 Year Warranty (Recreational Use) Specifications Chart Part No. 55601-SAM 55604-SAM 55605P-SAM 55607-SAM 55611-SAM 55612-SAM Description Trim tab plate only Lenco 12x24 matte finish - single Trim tab plate only Lenco...

Lenco Trim Tab Power Pig Tail Used with Lenco Trim Tab Kits. Part Number Length m 312889-BLA 0.9

Lenco Trim Tab Pro Control 1.52m Interface Cable Mercury Smartcraft Specifications Chart Part No. 557078-SAM

Lenco Trim Tab Pro Control Actuator Deutsch Plug Connector Kit (pair) Specifications Chart Part No. 557086-SAM

Lenco Trim Tab Pro Control CAN Bus Tee Connector Specifications Chart Part No. 557088-SAM

Lenco Trim tab Pro Control Wake Signal Adaptor Suit Non-Mercury Specifications Chart Part No. 557084-SAM Note Available Soon

Lenco Trim Tab Remote Gland Seal Kit Used as an alternative method by routing the actuator wires through the transom above or below the waterline. Contents (2) mounts, (2) gland seals and (6) mounting screws. Clam shell packaged.